Started the composite Transome

Well all the wood and grinding on the inside of the transom is done! That job took alot longer then I was expecting. 

Today I sprayed the outside transome with PVA for the skin that I will use for the inside. This will be used as a "frame" so I can pour the transome. If it doesn't make sense it will on the next post  

After the PVA dried I layed up two layers of +-45 Biax in opposite directions. Once it cures I will pull the skin off and cut it to fit the inside dimensions of the transome. That skin will get glassed in about 1.5 inches in from the factory transome and the NIDA POUR will go in-between. 

All Done